The Latest

Upcoming Events


Send press releases to Ernst@Agfax.com.

View All Events


Send press releases to Ernst@Agfax.com.

View All Events

Nebraska: Degree-Day Models Predict Western Bean Cutworm Flights

Ernst Undesser
From University of Nebraska-Lincoln Extension June 19, 2017

Nebraska: Degree-Day Models Predict Western Bean Cutworm Flights

Western Bean Cutworm

Introduction to Insect Degree-Day Models

One of the challenges to controlling insect pests in field crops is knowing when the damaging stage of the insect will be present in the field. Scouting for and effectively treating insects, if numbers are above the economic threshold, can be a challenge because the optimum time will vary from year to year.

Insect development is dependent on variable weather conditions such as air and soil temperature. Important stages in insect life cycles, such as egg hatch, pupation, adult flight and reproduction, can be predicted based on environmental temperatures.

By using a degree-day model, you can account for the effect of temperature on insect development and approximate when certain insect development events will occur by measuring degree-days.

Degree-days are units that measure how much heat an insect has been exposed to within an upper and lower temperature threshold. These temperature thresholds establish the range of temperatures that allow for insect growth and development.

By studying insect development in the laboratory and in the field, entomologists can determine these thresholds, as well as the number of degree-days that must be accumulated in order for a specific insect species to reach a certain stage in their development. These numbers will vary depending on the insect species.

One common way to measure degree-days is by taking the average temperature of each day and subtracting the lower threshold from that average:

[(Actual Minimum Temp + Actual Maximum Temp)/2] – Lower Threshold

For example given a minimum temperature of 50ºF, a maximum temperature of 85ºF, and a 38ºF lower threshold, degree-days for a given day might be calculated as

{(50 + 85)/2] – 38

[135/2] – 38 = 29.5 degree-days

Note:

  • If the average temperature [(Minimum Temp + Maximum Temp)/2] is lower than the Lower Threshold, change the average temperature to the Lower Threshold before subtracting the Lower Threshold.
  • If the average temperature [(Minimum Temp + Maximum Temp)/2] is higher than the Upper Threshold, change the average temperature to the Upper Threshold before subtracting the Lower Threshold.

A degree-day model will determine on which calendar date to start counting degree-days. After this date, degree-days from each day are accumulated to give the total cumulative degree-days.

Using Degree-Days to Predict Western Bean Cutworm Scouting

UNL Entomologists Tom Hunt and Robert Wright, along with University of Minnesota researchers Roger Moon and Bill Hutchison and PhD student Anthony Hanson published a new model in 2015 for the flight of western bean cutworm (Figure 1) that has improved predictions of cumulative moth flights and efficiency of field scouting.

This model shows that the best method for predicting timing of western bean cutworm flight used simple degree-day calculations (see example above) beginning March 1, with a 38°F lower threshold and a 75°F upper threshold.

The new cumulative flight model indicated that 25% of moth flight should be completed when 2,577 degree-days (Fahrenheit) have accumulated. Field scouting to estimate egg density is recommended at this time.

Western bean cutworm

Figure 1. (top) Western bean cutworm egg mass (left) and larva.

Wetern bean cutworm

Figure 2. Western bean cutworm

Predicting 2017 Western Bean Cutworm Flights in Nebraska

Using the new degree-day model and 2017 temperatures, the predicted flight patterns for western bean cutworm in Nebraska were calculated (Table 1).

Keep in mind that scouting is recommended at 25% of the moth flight. Actual temperatures at each location were obtained from the National Oceanic and Atmospheric Administration (NOAA) and from the High Plains Regional Climate Center for dates from March 1 to June 6, 2017. For dates after June 6, the five-year (2012-2016) average temperatures were used.

Due to the use of predicted rather than actual temperatures for these dates, we can expect a potential five-day window of error, with higher than average temperatures speeding up and lower than average temperatures slowing down insect development.

Table 1. Predicted Dates for 2017 Western Bean Cutworm Flights in Nebraska. Scouting is recommended at 25% of the moth flight.
LOCATION  5% 10% 25% 50% 75% 90% 95%
BENKELMAN 27-Jun 29-Jun 3-Jul 6-Jul 10-Jul 13-Jul 16-Jul
BIG SPRINGS 2-Jul 5-Jul 8-Jul 11-Jul 15-Jul 19-Jul 21-Jul
CLAY CENTER 29-Jun 2-Jul 5-Jul 5-Jul 12-Jul 16-Jul 18-Jul
CONCORD 5-Jul 8-Jul 11-Jul 14-Jul 18-Jul 21-Jul 24-Jul
GRAND ISLAND 1-Jul 3-Jul 6-Jul 10-Jul 13-Jul 17-Jul 20-Jul
HASTINGS 1-Jul 3-Jul 6-Jul 20-Jul 13-Jul 17-Jul 20-Jul
HOLDREGE 3-Jul 7-Jul 11-Jul 14-Jul 18-Jul 22-Jul 24-Jul
IMPERIAL 7-Jul 9-Jul 12-Jul 15-Jul 19-Jul 23-Jul 26-Jul
KEARNEY 4-Jul 6-Jul 9-Jul 13-Jul 17-Jul 21-Jul 23-Jul
MADRID 3-Jul 6-Jul 9-Jul 12-Jul 16-Jul 20-Jul 23-Jul
MCCOOK 30-Jun 2-Jul 6-Jul 9-Jul 14-Jul 16-Jul 19-Jul
NORTH PLATTE 8-Jul 11-Jul 14-Jul 17-Jul 21-Jul 24-Jul 27-Jul
O’NEILL 12-Jul 14-Jul 18-Jul 21-Jul 25-Jul 29-Jul 1-Aug
OGALLALA 5-Jul 7-Jul 11-Jul 14-Jul 18-Jul 21-Jul 24-Jul
SCOTTSBLUFF 4-Jul 6-Jul 10-Jul 13-Jul 17-Jul 21-Jul 24-Jul

WBC Scouting and IPM

Western bean cutworm can be a devastating pest for corn and dry bean fields, particularly in western and central Nebraska. Please refer to the Nebraska Extension NebGuide on this pest for more information and keep the following points in mind when considering scouting and treatment for western bean cutworm:

  • Scouting for WBC in corn can be much easier using Nebraska Extension’s Speed Scouting free mobile app or spreadsheet.
  • Genetically engineered Bt corn expressing Cry1F (Herculex) proteins will suppress WBC feeding, but does not eliminate all caterpillars. Control of WBC by Cry1F may be less effective in your area than in past years, although VIP3A is still highly effective. (See the updated Handy Bt Trait Table for those trait packages that protect against WBC.)
  • For corn that does not have Bt traits that protect against WBC, the treatment threshold is 5-8% of corn plants with eggs or larvae.

Degree-day models can help predict when scouting should occur and should be used in combination with other monitoring methods. UNL black light trap reports from North Platte, Clay Center, and Concord are additional resources for monitoring western bean cutworm and other crop pests.


Source: : http://cropwatch.unl.edu/2017/using-degree-day-models-predict-western-bean-cutworm-flights

Ernst Undesser
From University of Nebraska-Lincoln Extension June 19, 2017